M18 inductive proximity sensor for speed control ISP1-18.11.K
6...400rpm, Sn=8.0mm, 3-wire, PNP/NO, 10-30VDC, 250mA, M18x59mm
Unshielded type inductive proximity sensor ISP1-18.11.K for direct current, for control of revolutions in the range of 6 to 400 rpm. The sensor has a plastic cylindrical housing M18x59mm, with output type PNP with one normally open contact. The maximum distance of operation of the proximity sensor is 8,0mm. The sensor ends with a 3-wire PVC connecting cable with a length of 2m. The sensor has two LEDs, one showing the output state of the inductive sensor, and the other showing the length of the received impulses. The sensor's output is protected of overload and short circuit.
The presented proximity inductive sensor M18 serves to monitor the minimum permissible revolutions of rotation of shafts and the minimum permissible speed of movement of conveyor belts, elevators, lifts and other moving parts. It is used in direct current electrical circuits.
After applying the supply voltage the output of the sensor remain included for 7 seconds - the necessary time for acceleration of the slow-moving mechanisms. If turnovers of the rotating mechanism exceed the given ones, the output of the sensor remain on. But if turnovers the rotating mechanism are lesser than the given, the output of the sensor turn off. The minimum turnovers are set by trimmer potentiometer located at the back of sensor. It has two LED's: a red one - indicating the output signal of the sensor and green one - indicating the length of the incoming pulses.
Note: Sensor marked at the end with the letter "Z": after turning off the output, restore its operation by turning off and on the supply voltage (option on request).
|Range of regulation, N||6 ... 400 rpm|
|Maximum permissible revolutions, Nmax||24000 rpm|
|Switching distance, Sn||8,0 mm|
|Supply voltage, Us||10…30 Vdc (Ripple. ±10%)|
|Output voltage (max), Uout||35 Vdc (open collector)|
|Residual voltage (max), Ures||0,8 V (I = 250 mA)|
|Load current (max), Iout||250 mА|
|Protection of output (scanning), Iprot||350 mA (25°С)|
|Current consumption, Is||9 mA|
|Fall time and Rise time, tf / tr||0.6 µs / 0.2 µs|
|Operating temperature range, Tamb||-25°…+70° C|
|Degree of protection||IP67 (IEC144)|
|Output light indicator||2 x LED|
|Connection cable||3x0.25 mm², L=2 m, PVC|
|Overall dimensions||M18x1 mm, L=59 mm|
|Housing - plastic||PVC|
Overall dimensions (mm)
The presented proximity inductive sensor M18 is used in industrial systems as an automation tool for monitoring the minimum permissible revolutions of rotating shafts and the minimum permissible speed of movement of conveyor belts, elevators and other automated systems. The sensor monitors the speed of passage of metal objects in front of its active part. The proximity sensor for speed control is resistant to moisture and dust. It has a long service life thanks to the non-contact switching of the electrical circuit in which it is connected.
TYPE PARAMETERS OF UNSHIELDED SENSORS FOR SPEED CONTROL M18, DC
|ISP1-18.11.K||PNP / NO|
|ISP1-18.11.KZ||PNP / NO|